MOTOR permanent magnet powerful magnets. Series wound - No magnets inside - Motor only. 165 Amps/ 2800 RPM at full load / 7900 RPM.
Extra heavy duty aluminum cooling plate. 3 hp DC motor with 5/8 shaft built very tough - YouTube. Only motors with magnets can be turned into power generators (like the one below). Make wind turbine from DC motor Tread mill Wind generator DIY project - YouTube. Overall dimensions are 4.5" in diameter by 10" in length.1.75 long shaft fits common pulley /sprocket sizes. Heavy duty aluminum mounting plate. Bolt pattern is 4 X 3/8" threaded holes spaced 6" apart (centered). 2700 RPM at peak load (working). 8000 RPM unloaded at full rated battery voltage.
Lots of torque at low RPM's! Bolt pattern is four 3/8" bolt holes spaced 4 3/8" apart. Rain, ice and weather proof electronics. / Box dimensions - 11"X 9"X 8.This is a very substantial and solid motor at 24 lbs! Coated with heavy powder coating, corrosive sealed for salt water use and all brass hardware! Heavy duty plate, bearings and rotor for decades of very dependable service life! Use a 120 VDC rated fuse or breaker to keep your motor safe. If breaker snaps just push to reset and your back in business : (If you do not use a breaker you will be'dead in the water with a fused motor that will take hours to replace). THIS MOTOR IS BUILT RIGHT. VERY HIGH QUALITY AND SOLID DESIGN.
The item "3 HP Kirby DC MOTOR 13.6VDC/ 2.68 hp@ 12 VDC 12 VOLT Electric Car Bike Kart" is in sale since Monday, May 4, 2020. This item is in the category "Business & Industrial\Industrial Automation & Motion Controls\Electric Motors\General Purpose Motors". The seller is "hornetwind" and is located in Lancaster, California. This item can be shipped worldwide.